Successfully Installing Bathroom Basin Taps

If you are doing a bathroom remodeling project, and that project involves the installation or refurbishing of your bathroom vanity, then you will probably need to install a new set of bathroom basin taps. This is not a difficult or complicated thing to do, but you will need a few tips and pointers.

First of all, what is the difference between a tap and a faucet? Well, in simplest terms a tap is a water control valve with its own separate spigot. A faucet will usually have hot and cold water controls with a single spigot, into which both the cold and hot water will flow. If you have both hot and cold water basin taps for your bathroom vanity you will have two spigots as well. Typically spigots are used instead of water faucets because they are smaller and more compact and are more suitable for bathroom vanities because of the limited available countertop space.

Before installing your new bathroom basin taps you will of course need to disassemble the old ones. Make sure your hot and cold water lines into your bathroom vanity have been turned off. Then drain the lines of water by turning the faucets on. You will probably need a screwdriver and a wrench to take your old taps off. Be careful when you take your old taps off that you do not scratch or crack the porcelain basin around the mounting holes.



Once your old taps have been removed, clean the mounting holes on both the top side and underneath of the basin. Your new basin taps will probably have a leaflet with some manufacturers instructions and guidelines included -- read these over very carefully, and make sure you follow their directions to the letter.

During the installation, if your basin tap manufacturer indicates that you should use washers or gaskets or other special hardware or preparations, make sure you use the exact items that they recommend. You will need to make absolutely sure that your new taps do not leak water -- you will need to check underneath the vanity to make sure there are no leaks where your waterline joins with the tap, and you also need to check topside to make sure there are no leaks around the sink or basement area.

Again, when installing your new basin taps make sure that you do not damage the porcelain sink basin by cracking or chipping it near the basin tap installation holes. Do not use a wrench to tighten the taps on the top side, as you can scratch the metal finish. Follow your manufacturers instructions and hand-tighten and then adjust it from below with a wrench, as necessary.

When everything is in place, turn on your new bathroom basin taps and let them run for a minute or so. Check for leaks again, both above and below the countertop. If you can't feel any moisture around the threads or mountings, and don't see any drips below on your vanity shelf, then your installation has been successful. Congratulations!

For more info : - bathroom basin taps

bathroom taps uk

Comments

Popular posts from this blog

The Convenience of Best Shower Baths

Shower faucets: pick the right shower for you and knowledge a Leisurely bath

A Quality Bathroom Tap Equals A Happy Family